Axle set screw, stripped thread. Requires fabrication of better hub.
Date: 13/Jun/2014
Owner: Burnit0017
Views: 772
DSCN3429
Plan on adding levitation magnet track to the ramps.
Date: 13/Jun/2014
Owner: Burnit0017
Views: 621
DSCN3430
Plan on driving 3 phase PMA, 1 phase will drive a linear motor on each track. The remaining phases will be used to generate electricity.
Date: 13/Jun/2014
Owner: Burnit0017
Views: 649
DSCN3431
Boring steam cylinder for scotch boxer engine
Date: 14/Jun/2014
Owner: Burnit0017
Views: 636
DSCN3432
turning piston
Date: 14/Jun/2014
Owner: Burnit0017
Views: 742
DSCN3434
using cotton cord for piston rings
Date: 15/Jun/2014
Owner: Burnit0017
Views: 624
DSCN3435
New engine configuration will allow for larger flywheels
Date: 17/Jun/2014
Owner: Burnit0017
Views: 634
DSCN3437
basic engine configuration
Date: 17/Jun/2014
Owner: Burnit0017
Views: 648
DSCN3438
GRAM magnet mass accelerator, using cam and scotch yoke on center axis
Date: 20/Jun/2014
Owner: Burnit0017
Views: 635
DSCN3439
Date: 20/Jun/2014
Owner: Burnit0017
Views: 627
DSCN3440
Date: 20/Jun/2014
Owner: Burnit0017
Views: 630
DSCN3442
Gram will always require a external power source to operate. Solar is to expensive, I live in a low wind area. Fabricating steam engine to drive a PMA. Then I can complete the fabrication of GRAM.
Date: 23/Jun/2014
Owner: Burnit0017
Views: 583
DSCN3444
Date: 23/Jun/2014
Owner: Burnit0017
Views: 612
DSCN3445
Date: 23/Jun/2014
Owner: Burnit0017
Views: 567
question
Basic question, if a motor is running at 10 watts and the motor is driving a torque multiplier and the torque multiplier is driving a PMA with a MPPT circuit, will the output power of the PMA be greater than 10 watts?????
